5 Takeaways That I Learned About Floors

How To Recoat Hardwood Floors Over time, it is obvious that your hardwood floor will become scratched and dull from general wear and tear. On the off chance that your hardwood floor has a polyurethane surface, it can ordinarily be recoated without the need to sand the whole floor first. Recoating is fundamental if the floor is gently scratched and worn, the finish has not worn, and it doesn’t have a gathering of wax or different chemicals. These will bring about adhesion issues and make the floor reject the new finish which can lead to detaching and shedding. These will cause adhesion problems and cause the floor to reject the new finish which can cause peeling and flaking. Recoating is an easy process that entails deep cleaning and scuffing the timber surfaces uppermost layer of the finish. Then, a new fresh layer of finish is applied. Recoating will invigorate the polish and remove any slight staining that has yet to infiltrate the timber. It restores your wood floor and lengthens the life of its defensive finish layers. It is advisable that you recoat your floor while it still looks good. This will extend the life of the floor and decrease the number of times it has to be refinished. Recoating a hardwood floor ought not to be confused with refinishing a hardwood floor. The latter involves extensively sanding the floor to expose the wood, important when there are deep scratches, damage or if the floor has been waxed. To test if your floor should be recoated, you ought to carry out a small patch test in an unnoticeable region. It is ideal to do the testing along a wall where cleaners might have accumulated. Clean the region extensively using a wood floor cleaner and then moderately sand with fine sandpaper. You ought to then remove all dust particles. Then apply polyurethane floor finish to the section and wait for 24 hours. The layer should be fine, not undulated or an orange shell feel. Scratch the layer with moderate force using a coin and it ought not to flake or peel. In the likelihood that the surface fails these tests, the floor will require being broadly sanded and revamped. For recoating to happen on your hardwood floor, it needs to initially be moderately sanded with a screen disk. From that point, the floor ought to be cleared and vacuumed to take out the wood dust. You ought to then moist a tack cloth with clean mineral spirits and brush it over the floor to collect any fine dirt and oily left overs. At the time of fitting the finish, it is recommended you make use of a similar finish as was used to guarantee compatibility. In case the current coating is not compatible with the fresh one, there will be issues like shedding that can happen.What Research About Flooring Can Teach You

READ  Why No One Talks About Products Anymore

Doing Floors The Right Way